By repeatedly pressing the upper button (get closer), the following changes occur in the state of the car wash.
The car appears in front of the car wash, the state of the car wash point is unchanged
With the next click it gets into the correct position for washing and the status of the car wash changes to "Calling".
With the next click the car is behind the car wash and the status returns to "Idle".
The next click on the same button causes the car to disappear.
By repeatedly pressing the lower button (move away), the same changes will happen but in the opposite direction.
The washing didn't start because the wash point was not preauthorized.
Authorizing Car Wash
The car wash can be authorized through the Demo POS program. A washing program can also be selected.
First, the washing program is selected, and then the car wash is authorized with the same button as the fuelling point.
When wash point is authorized and car is correctly positioned after 3 seconds the washing will start. During the washing process, the buttons are disabled, you can't move the car. The stopwach up-right shows time in seconds left (on the image it is 9).
When the time runs out the washing is done and the state is updated accordingly. The buttons are enabled again and you can move the car away.
